I checked the factory original, and noted that a "front to back" measurement of the extractor arm shows that the replacement is. All this appears to be that there is something oversized with the extractor. I then loosened the barren tightening nut a tad and it worked fine, except that there is now a small space between the action and barrel shoulder (and the barrel is loose of course). Building the Stevens Favorite Single Shot Rifle, Part One The. The entire build thread can be found in the Gunsmithing section of Metalworking Fun. 94C Series M and others various Models and Gauges Extractor / Ejectors. Tasks left to do are drill and rifle the barrel, make the front sight and rear leaf sight, make and fit the extractor and heat treat and blue all of the parts.
![which extractor for stevens favorite 22 rifle which extractor for stevens favorite 22 rifle](https://homesteadparts.com/shop/images/s5a.jpg)
I then pulled everything apart and installed the extractor/ejector with the action attached to the barrel group. Stevens Favorite 1915 Rifle Gun Stock and forend set with buttplate screws. Everything fit, but the final pull up was very hard and the ejector wouldn't pop out as intended.
![which extractor for stevens favorite 22 rifle which extractor for stevens favorite 22 rifle](http://www.wisnersinc.com/wp-content/uploads/2015/03/Stevens-441.jpg)
#Which extractor for stevens favorite 22 rifle install
I did the initial install with the action off of the barrel and made sure the ejector was compressed before installing the action back to the barrel. The Stevens Favorite to which I refer is a Model 1915. I've tried to install with the lever screw in place and then push back the ejector to work the block pin through, and tried to install it vise versa (easier by far). gives a very good description, and Ive learned some things about my own rifle. I have fought the installation throughout. 203"), minus opening the extractor top cut, and was putting it together to do a general non-firing test to make sure all worked as planned. I have done the initial general extractor fitting (had to take off about. In the process of getting it back to shooting shape for my 9yr old left handed son, I purchased a new firing pin, block and lever screws, and a new extractor/ejector from Wisners. It's a later model with the round barrel and extractor/ejector. I purchased a decent Stevens Favorite 1915 in.